Del papildomu funkciju programavimo Octavia 2 FL

[09] - Central Electronics
Lighting
All modifications are found in Found in [Coding - 07] > Long Coding Helper unless otherwise noted. Click on each of the Bytes and Bits for the documented options and check or un-check the appropriate boxes as shown in the example below:
[Select]
[09 - Cent. Elect.] Or the module you intend on tweaking as per the list below
[Coding - 07]
[Long Coding Helper]
Click on each of the Byte numbers in row 3) and you'll see the selectable options below. Check or Un-check the boxes for the desired results. Example: Daytime Running Lights (North America)
Close the Long Coding Helper by clicking the Windows X box on the top right of the screen or clicking the Exit button on the top left of the screen to send your altered Coding value back to the Coding screen.
[Do It!]
.
Daytime Running Lights - The systems are coded differently depending on the market:

"Daytime Running Lights (Scandinavia) active" should result in ALL exterior lights running
"Daytime Running Lights (North America)" should result in headlights Only lights running

Fogs as Daytime Running Lights when applicable
Enable "Daytime Running Light via Fog Lights"

Daytime Running Lights Dimming If DRLs are Halogen bulbs (not Xenon) the dimming resolution may be adjusted.
Select the Byte with "Daytime Running Lights Dimming" "Decimal Value (Resolution: 1%)" and alter the value.
Additional Light Dimming bits are available for other lighting circuits.

Front and /or Rear Fog Light dimming behavior with High Beams or Trailer
Depending on equipment level, additional coding bits may be available.
Front Fog Lights deactivated with High Beam
Rear Fog Light Deactivation with Trailer active

Cornering Lights via Front Fog Lights active when applicable
Enable "Internal Turn Light Control Algorithm active"
Next, Enable "Turn Lights via Fog Lights"
Additional [Adaptation - 10] options may be available for dimming duration activation/deactivation
Notes: After Cornering Lights via Front Fog Lights is active, the lights may work under the following conditions:

The headlights must be turned on and the steering wheel must be in the turning direction.
The headlights must be turned on and the turn signal must be on in the turning direction.

Comfort Turn signals
Comfort Turn signals may be turned On -or- Off via coding. The number of flashes cannot be adjusted.

Emergency Brake Warning active The Brake Lights should flash under Panic stopping conditions.
Enable "Emergency Brake Flash Light active"

Coming Home / Leaving Home
Modifications are found in Found in [Coding - 07] > Long Coding Helper. Click on each of the Bytes and Bits for the documented options and check and un-check the appropriate boxes. Additional Adaptation -10 Channels should be available after enabling coding options.
Coming Home Several Bits may control CH options such as On / Off and Manual or Automatic.
"Rain-/Light sensor installed"
"Coming-Home active"
"Coming-Home Logic (0 = Old / 1 = New)"
Note:If the vehicle is not equipped with an "Auto" headlight switch and a (RLS) light sensor the results may vary. The description should be found in your owner's manual.
Leaving Home

"Coming-Home Mode via (0 = Personalization / 1 = Lightsensor)"
"Assistance Driving Light & Leaving Home active"
"Leaving-Home Variant (0 = LH in LDS / 1 = No LH in LDS)"

va pradžiai jei moki anglu ;)